Symphonic WF32L6 Owner's Manual - Page 18

WATCHING TV CHANNEL SELECTION You can select the channel by using either [CH K/L] or Channel number buttons. How to select the channel in each way is shown below. POWER INPUT SLEEP SELECT 12 45 78 -0 SETUP 3 6 AUDIO 9 STILL SCREEN MODE ENTER BACK INFO CH RETURN VOL. MUTE CH 1 Using [CH K/L], or Channel number buttons and pressing [ENTER]. • Using [CH K/L], change the channel. • Same operation is available with [CHANNEL K/L] on the top panel of the main unit. • When you select a channel, press the channel number you want to view with Channel number buttons. The selected channel will be displayed. - When selecting analog channel 12 1 2 ENTER - When selecting digital channel 12-1 Be sure to press [-] before entering the minor-channel number. 1 2 - 1 ENTER • If the channel broadcasts NTSC and ATSC both and you don't press [-], then you will receive the NTSC channel only. The moment you press [-], the lowest memorized digital channel will be displayed. • When you press [CH RETURN], the previously selected channel will be selected. NOTE: • In the DTV broadcasting, one channel sometimes broadcasts multiple programs depending on the air time. In this case, the main channel is called major channel and the minor-channel is called minor channel. About minor-channel broadcasting: There may be different programs being broadcast on minor-channels through a single channel from ATSC. You can watch each minorchannel program being broadcast by selecting one of the minor-channels. NTSC CH4 18:00 ATSC CH4-1 No signal No signal 18:30 CH4-1 CH4-2 CH4-3 19:00 CH4-1 No signal CH4-3 19:30 CH4-1 CH4-2 No signal 20:00 : change automatically : change manually by pressing [CH / ] on your remote control NOTE: • "No Signal" will appear on the screen after the minor-channel broadcast is over. You will need to change the channel to continue watching another TV program. VOLUME ADJUSTMENT This section describes how to adjust the volume when viewing TV. The Mute function, which is useful when you have a visitor or a phone call, will be also described. BACK INFO CH RETURN VOL. MUTE CH 1 Using [VOL. X/Y] or [MUTE]. [VOL. X/Y] • You can adjust the audio volume with [VOL. X/Y]. • The volume bar is displayed at the bottom of the screen when adjusting the volume. • Same operation is available with [VOLUME X/Y] on the top panel of the main unit. Volume 20 • The volume bar display will automatically disappear in a few seconds. [MUTE] • Press [MUTE] on the remote control to mute the sound. • To release the Mute status, press [MUTE] again or press [VOL. X/Y]. Mute • "Mute" is displayed on the screen for a few seconds. 18 EN