TASCAM CD-6010 Owners Manual - Page 32

7 - Other Functions Changing the playback time display mode You can select the playback time that is shown on the display. During playback or when paused, press the DISPLAY [LOCK] button on the player or the DISPLAY button on the remote. Each press of the button cycles through the three types of time display. The currently selected display mode is shown in the playback time mode display area. •• T.REMAIN: total remaining time is displayed •• REMAIN: remaining time of the current track is displayed •• Nothing: elapsed time of the current track is displayed NOTE •• When an audio CD is stopped, the total recording time is always shown regardless of whether or not T.REMAIN or REMAIN appears. •• For data CDs, neither the total time when stopped, nor the remaining time or total remaining time during playback are shown. (Only the number of tracks or track number appears.) •• In program playback mode, remaining time shows the time until playback of the program ends. In single playback mode, remaining time shows the remaining time in the track. •• In program playback mode, the total time shown is for the program. •• The playback time display mode setting is retained even when the power is turned off. Frame time display setting You can set whether or not the frame time is shown during playback. To set the frame time display, use the 17 FRAM menu item (default value: ON). NOTE The frame time display on/off setting is retained even when the power is turned off. End of track warning (TRACK EOM) When nearing the end of a track, an end of track warning indication can be shown on the display and a "21 EOM TRACK TALLY" signal can be output from the CONTROL I/ O PARALLEL connector. With data CDs, an end of track warning will not appear on the display. The CONTROL I/O PARALLEL "21 EOM TRACK TALLY" signal will be output as a pulse when the file playback ends. 32 TASCAM CD-6010 By setting in advance the number of seconds before the track end that the warning is shown, when playback reaches that point, the ":" in the time display will begin blinking. At the same time the CONTROL I/O PARALLEL "21 EOM TRACK TALLY" signal will be output. M S F Use the 10 EOM_T menu item to set the value from among the following options. Options: OFF, 0, 5, 10, 15, 20, 25, 30 (default value), 35 For values other than OFF, the number indicates the number of seconds before the end of the track that the warning begins. However, when set to 0, no warning will be shown on the display when track playback ends, but a "21 EOM TRACK TALLY" signal will be output from the CONTROL I/O PARALLEL connector as a pulse. At the default value, 30 seconds before the end of the track, the ":" begins to blink and the CONTROL I/O PARALLEL "21 EOM TRACK TALLY" signal is output NOTE The TRACK EOM function setting is retained even when the power is turned off. End of disc warning (Disc EOM) You can set the unit to output a "23 EOM DISC TALLY" signal from the CONTROL I/O PARALLEL connector when nearing the end of a disc a few seconds before it ends. Use the 06 EOM_D menu item to set the time of the EOM function. Options: OFF, 0, 5, 10, 15, 20, 25, 30 (default value), 35 For values other than OFF, the number indicates the number of seconds before the end of the disc that the warning begins. When set to 0, a "23 EOM DISC TALLY" signal will be output from the CONTROL I/O PARALLEL connector as a pulse when disc playback stops. NOTE The DISC EOM function setting is retained even when the power is turned off.