TASCAM CG-1800 Owners Manual - Page 24

8 - Other functions Setting the startup preset You can set the preset used at startup when this unit is turned on. Make this setting on the UTILITY 1 page. 1. Press the MENU button to open the UTILITY 1 menu page, and turn the MULTI JOG dial to select the STARTUP item. 2. Press the MULTI JOG dial to open the STARTUP MODE screen. 3. Turn the MULTI JOG dial to set the preset used at startup. Option LAST (default) PRESET 1 PRESET 2 PRESET 3 PRESET 4 FACTORY Function Startup with last used settings Startup with the corresponding preset settings Startup with factory default settings NOTE The STARTUP item setting cannot be restored to the factory default. 4. Press the MULTI JOG dial to confirm the selection and return to the menu. Calibrating the internal oscillator The importance of calibration This unit has an OCXO (oven-controlled crystal oscillator) that provides 0.01ppm high-precision frequency output. However, every clock generator, including this one, can normally be expected to change over time. In order to enable continued use with high-performance, this unit has a function for calibrating the internal oscillator. If you connect and input a 10MHz signal generated from a GPS signal or a PPS signal, for example, to the dedicated CALIBRATION INPUT connector, the unit will recognize it automatically and calibrate the internal clock. Checking the unit firmware version Follow these procedures to check this unit's firmware version. Do this before updating the firmware, for example. 1. Press the MENU button repeatedly to open the UTILITY 2 menu page, and turn the MULTI JOG dial to select the VERSION item. 2. Press the MULTI JOG dial to open the VERSION screen. The VERSION screen shows information about the firmware version and build number. 3. Press the EXIT/CANCEL button to return to the menu screen. NOTE When the VERSION screen is open during step 2 above, press the MULTI JOG dial to switch to firmware updating. For the latest information about updating firmware, visit the TEAC Global Site (http://teac-global.com/). Checking the error log Follow these procedures to check the error log, which contains information about past errors. Check the error log from the LOG page. 1. Press the MENU button repeatedly to open the LOG page menu, and turn the MULTI JOG dial to select the ERROR LOG item. 2. Press the MULTI JOG dial to open the ERROR LOG screen. In the error log, each error is shown on a separate page. Error log page example 1 Error log number These numbers are assigned to errors in order as they are added to the log. 2 Error date and time This shows when the error was added to the log. 3 Error summary This shows the error code and signal affected as described in the Overview of error codes table. (See "Overview of error codes" on page 10.) 4 Signal that error affected This shows the signal that the error affected. 5 Error result This shows what happened because of the error. 6 Recovery date and time This shows when the unit recovered from the error. 7 Recovery summary This shows how the unit recovered from the error. 8 Recovery result This shows what happened when the unit recovered. 24 TASCAM CG-1800/CG-1000