TASCAM EZ CONNECT wner s Manual - Page 21

2 - TASCAM MX CONNECT q RS-232C SETTINGS Make these settings to use the RS-232C connector (9-pin D-sub RS-232C standard) on the MX-8A unit to operate it from a computer or other external device by serial control. Tap these fields to open option lists. BAUD RATE Set the transmission speed (baud rate). Options 4800 bps, 9600 bps, 19200 bps, 38400 bps (default), 57600 bps PARITY BIT This sets parity bit use. Options: NONE (default), EVEN, ODD STOP BIT This sets the stop bit. Options: 1 (default), 2 DATA LENGTH This sets the data length. Options: 7 bit, 8 bit (default) NOTE For information about the MX-8A unit's RS-232C command protocol, please contact TASCAM customer support (details at the back of this manual). You can download the TASCAM Mixer protocol for MX-8A from the TEAC Global Site (http://teac-global.com/). EZ CONNECT page On the EZ CONNECT page, the operation details can be set for TASCAM EZ CONNECT, which is designed for end-users. Up to 8 areas can be set. NOTE Download the TASCAM EZ CONNECT installer from the TEAC Global Site (http://teac-global.com) and install the software. For details about installation, see "Installing the dedicated software" on page 4. 1 AREA selection tabs Operation details for TASCAM EZ CONNECT can be set separately for each AREA tab. These show the names set in the AREA NAME setting fields. Tap this area to switch AREA tabs. 2 AREA NAME setting field Set the name shown on the AREA tab on the EZ CONNECT page. Tap this area to make the cursor blink, enabling character input. Up to 96 English letters and numbers can be input. NOTE The name set here will also be shown in the TASCAM EZ CONNECT app. (see "Connecting TASCAM EZ CONNECT with an MX-8A" on page 24) 3 AREA PASSWORD setting field This sets the password used to log in to TASCAM EZ CONNECT. (see "Connecting TASCAM EZ CONNECT with an MX-8A" on page 24) The AREA password can be set separately for each AREA tab. The same password as used by another area cannot be set. Tap this area to make the cursor blink, enabling character input. In addition to uppercase and lowercase alphabet letters and numbers, the following characters can also be used The maximum number of characters is 16. NOTE The number of characters that can be used for the password is different from the PASSWORD item on the SETTINGS page. 4 SOURCE SELECT setting area Set the source selections operated using TASCAM EZ CONNECT. (see "Setting the SOURCE SELECT area" on page 25) 5 VOLUME setting area Select the volume adjusted by TASCAM EZ CONNECT. (see "Setting the Volume Screen" on page 26) TASCAM MX CONNECT 21