TASCAM MZ-223 Owners Manual English Francais Espanol Deutsch Italiano Japanese - Page 10
Preparation
View all TASCAM MZ-223 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
; Cord holder Attach the power cord of the included AC adapter (TASCAM PS-M1524) here to prevent accidental disconnection. (See "Connecting other equipment" on page 10.) z DC IN 15V connector Connect the DC plug of the included AC adapter (TASCAM PS-M1524) here. x MONITOR OUT jacks These RCA pin jacks are analog monitoring outputs. c MAIN OUTPUTS 1-3 (BALANCED) jacks These analog outputs are XLR jacks. (1: GND, 2: HOT, 3: COLD) Preparation Use the ATTENUATOR (h) switches to change the output levels. v MAIN OUTPUTS 1-3 (UNBALANCED) jacks These RCA pin jacks are analog outputs. Use the ATTENUATOR (h) switches to change the output levels. b LINE A/B input jacks These RCA pin jacks are analog line outputs. Record players can be connected to the LINE A input jacks of channels 1-2. When connecting a record player to these jacks, also connect its grounding wire to the | (GND) jack (k), and set the LINE/PHONO input selection switch (l) to PHONO. Connecting the power Use the included AC adapter (PS-M1524) to connect a power supply to the unit as shown below. Power outlet DC plug TASCAM PS-M1524 (included) CAUTION Always use the AC adapter (PS-M1524) that was shipped with the unit. Using a different AC adapter could cause malfunction, overheating, fire or other problems. NOTE The AC adapter for the unit includes two types of adapter cords. Attach the type of AC adapter cord that matches the power outlet that you are using. Attaching the cord In order to prevent the cord from becoming disconnected during use, attach it to the cord holder (;) when connecting it to the unit. 1. Remove the cord holder (;) screw. 2. Place the cord in the cord holder (;). 3. Tighten the cord holder (;) screw. Connecting other equipment This is an example of MZ-223 connections. Precautions before making connections 00Carefully read the operation manuals of the de- vices to be connected and then connect them correctly. 00Before making connections, turn this unit and all equipment to be connected off (standby). 00Install all connected devices, including this unit, so that they are powered from the same line. When using a power strip or similar device, be sure to use one that has high current capacity (thick cable) in order to minimize fluctuations in power voltage. 00When connecting audio devices, minimize the channel 1-5 GAIN knobs (j) and faders (8), and the OUTPUT VOL (q) and PHONES VOLUME (a) knobs. Failure to do so could cause sudden loud noises from monitoring equipment, and this could damage the equipment or harm hearing. 10 TASCAM MZ-223