TEAC NT-503DAB Owner s Mamual English Francais Espanol - Page 20
Settings continued, Upconversion, PCM digital filter, Clock sync, Line output
View all TEAC NT-503DAB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Settings (continued) Upconversion Use to activate the upconversion circuit when receiving PCM format signals. oo See page 15 for the relationships between input sampling fre- quencies and sampling frequencies after upconversion. *UPCONVERT > OFF OFF The original input signal is sent directly to the D/A converter without upconversion. 2Fs If the input audio signal is less than 2× a standard sampling frequency (32, 44.1 or 48 kHz), it is upconverted 2× and then sent to the D/A converter. 4Fs If the input audio signal is less than 4× a standard sampling frequency (32, 44.1 or 48 kHz), it is upconverted 4× and then sent to the D/A converter. 8Fs If the input audio signal is less than 8× a standard sampling frequency (32, 44.1 or 48 kHz), it is upconverted 8× and then sent to the D/A converter. DSD The input source is converted to DSD digital format, and then sent to the D/A converter. PCM digital filter Use to set the digital filter when receiving PCM format signals. *PCM D-FILTER > OFF OFF The digital filter is disabled. FIR SHARP An FIR filter with a steep roll-off is used to sharply cut signals outside the audio band. FIR SLOW An FIR filter with a slow roll-off is used to gently cut signals outside the audio band. SDLY SHARP A short delay filter with a steep roll-off is used to sharply cut signals outside the audio band. SDLY SLOW A short delay filter with a slow roll-off is used to gently cut signals outside the audio band. oo When receiving signals at 352.8 kHz or 384 kHz, the digital filter will be disabled during playback regardless of this setting. DSD digital filter Use to set the digital filter when receiving DSD format signals. *DSD D-FILTER > CUTOFF 150kHz CUTOFF 50kHz 50kHz cutoff frequency CUTOFF 150kHz 150kHz cutoff frequency Clock sync oo Clock sync is only possible when the input source is USB (rear USB port), NET or USBf (front USB port). *CLOCK SYNC > OFF OFF No clock sync is used. ON This unit's master clock will be synchronized to the 10MHz clock input through the clock sync input (10MHz IN) connector. Line output *LINE OUT > RCA Use to select the connectors that output analog audio. oo Output through both the RCA connectors and the XLR connec- tors at the same time is not possible. RCA Output through the RCA connectors. XLR2 Output through the XLR connectors with 2: HOT polarity. XLR3 Output through the XLR connectors with 3: HOT polarity. 20