TP-Link AP500 AP500 V1 User Guide - Page 9
Position Your AP Device - reset
View all TP-Link AP500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Chapter 1 Item Ethernet Reset WPS LED On/Off Power Antennas Description One LAN 10/100/1000Mbps Auto-Negotiation RJ45 Port connects to a network device. The switch for the reset function. With the device powered on, use a pin to press and hold the Reset button for five seconds until the Power LED starts blinking, then release the button. Press and hold this button for two seconds to enable the WPS function. When the WPS LED blinks slowly, the device is trying to connect or to be connected. Press this button to turn on or turn off the LEDs. The switch for the power. Press it to power on or off the AP device. The power port connects to the provided power adapter. Used for wireless operation and data transmit. Upright them for the best Wi-Fi performance. 1. 4. Position Your AP Device • Place your AP device in a well-ventilated place far from any heater or heating vent • Avoid direct irradiation of any strong light (such as sunlight) • Keep at least 2 inches (5 cm) of clear space around your AP device • Operating Temperature: 0℃~40℃ (32℉~104℉) • Operating Humidity: 10%~90%RH, Non-condensing Generally, your AP device is placed on a horizontal surface. It also can be mounted on the wall as shown below. Note: The diameter of the screw, 4mm