TP-Link AV1000 TL-PA7020P KIT V1 User Guide - Page 13

TL-PA7020P AV1000 2-port Gigabit Passthrough Powerline Adapter 2.4 Hardware Connection - Internet This section describes how to connect the powerline adapter into your existing ADSL broadband connection via ADSL Ethernet port. Follow the procedures described below to connect the powerline adapter to your ADSL broadband connection: 1．Connect one end of the provided Ethernet (RJ45) cable to the Ethernet port of the powerline adapter. 2．Connect the other end of the Ethernet (RJ45) cable to an available Ethernet port of your ADSL broadband Router. 3．Plug the powerline adapter into a wall socket next to the computer. 4．Turn on your computer. 5．Check and confirm that the Power LED , Powerline LED powerline adapter are ON. The hardware connection mechanism is shown below: , and Ethernet LED on the 1000Mbps 1000Mbps 1000Mbps  Note: Where the MAINS plug or an appliance coupler is used as the disconnected device, the disconnect device shall remain readily operable. The idle wall sockets or electrical outlets in your household electrical circuit can be used normally without interference from the network. 7