TP-Link T2600G-28TS TL-SG3424 T2600G-28TS V1 CLI Reference Guide - Page 131
radius
View all TP-Link T2600G-28TS TL-SG3424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet) Example Configure the Control Type for Gigabit Ethernet port 20 as "port-based": T2600G-28TS(config)#interface gigabitEthernet 1/0/20 T2600G-28TS(config-if)#dot1x port-method port-based 18.12 radius Description The radius command is used to configure the parameters of radius. Syntax radius { [auth-pri ip] [auth-sec ip] [auth-port port] [acct-pri ip] [acct-sec ip] [acct-port port] [auth-key { [ 0 ] password | 7 encrypted-password } ] [acct-key { [ 0 ] password | 7 encrypted-password } ] } no radius { auth-port | auth-key | auth-pri | auth-sec | acct-port | acct-key | acct-pri | acct-sec } Parameter auth-pri ip -- The IP address of the authentication server. auth-sec ip -- The IP address of the alternative authentication server. auth-port port --The UDP port of authentication server(s) ranging from 1 to 65535. The default value is 1812. acct-pri ip -- The IP address of the accounting server. acct-sec ip -- The IP address of the alternative accounting server. acct-port port -- The UDP port of accounting server(s) ranging from 1 to 65535. The default value is 1813. auth-key { [ 0 ] password | 7 encrypted-password } -- 0 and 7 are the encryption type. 0 indicates that an unencrypted password will follow. 7 indicates that a symmetric encrypted password with a fixed length will follow. By default, the encryption type is 0. "password" is the shared password for the switch and the authentication servers to exchange messages which contains 31 characters at most. The question marks and spaces are not allowed. "encrypted-password" is a symmetric encrypted password with a fixed length, 115