TP-Link T2600G-28TS TL-SG3424 T2600G-28TS V1 CLI Reference Guide - Page 58
switchport dot1q-tunnel mode
View all TP-Link T2600G-28TS TL-SG3424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Syntax switchport dot1q-tunnel mapping c-vlan sp-vlan [descript] no switchport dot1q-tunnel mapping c-vlan Parameter c-vlan -- Customer VLAN ID, ranging from 1 to 4094. sp-vlan -- Service Provider VLAN ID, ranging from 1 to 4094. descript -- Give a description to the VLAN Mapping entry, which contains 15 characters at most. Command Mode Interface Configuration Mode (interface gigabitEthernet / interface range gigabitEthernet / interface port-channel / interface range port-channel) Example Add a VLAN Mapping entry on the Gigabit Ethernet port 1/0/3 with the Customer VLAN as VLAN 2 and the Service Provider VLAN as VLAN 3: T2600G-28TS(config)#interface gigabitEthernet 1/0/3 T2600G-28TS(config-if)#switchport dot1q-tunnel mapping 2 3 6.5 switchport dot1q-tunnel mode Description The switchport dot1q-tunnel mode command is used to configure the VPN port's mode. To close this VPN port, please use the no switchport dot1q-tunnel mode command. By default, no port has been configured as the VPN port. The VPN port mode uni and nni cannot switch to each other directly, so please close the VPN port and switch to the other mode if needed. Syntax switchport dot1q-tunnel mode { uni/nni } no switchport dot1q-tunnel mode Parameter uni --The port connected to the clients. nni --The port connected to the ISP. 42