TP-Link T2600G-28TS TL-SG3424 T2600G-28TS V1 CLI Reference Guide - Page 203
monitor session source interface
View all TP-Link T2600G-28TS TL-SG3424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
26.2 monitor session source interface Description The monitor session source interface command is used to configure the monitored port. To delete the corresponding monitored port, please use no monitor session source interface command. Syntax monitor session session_num source interface gigabitEthernet port-list mode no monitor session session_num source interface gigabitEthernet port-list mode Parameter session_num -- The monitor session number, can only be specified as 1. port-list -- List of monitored port. It is multi-optional. mode -- The monitor mode. There are three options: rx, tx and both. Rx (ingress monitoring mode), means the incoming packets received by the monitored port will be copied to the monitoring port. Tx (egress monitoring mode), indicates the outgoing packets sent by the monitored port will be copied to the monitoring port. Both (ingress and egress monitoring), presents the incoming packets received and the outgoing packets sent by the monitored port will both be copied to the monitoring port. Command Mode Global Configuration Mode User Guidelines 1. The monitoring port is corresponding to current interface configuration mode. 2. Monitored ports number is not limited, but it can't be the monitoring port at the same time. 3. Whether the monitoring port and monitored ports are in the same VLAN or not is not demanded strictly. 4. The monitoring port and monitored ports cannot be link-aggregation member. Example Create monitor session 1, then configure port 4, 5, 7 as monitored port and enable ingress monitoring: 187