TP-Link TL-PA201 User Guide - Page 30

TL-PA201 200Mbps Powerline Ethernet Adapter Join an existing Powerline AV Network: Powerline adapter A and Powerline adapter B form a HomeplugAV Network, Powerline adapter C wants to join this network. Step 1. Press and hold the Pair button on Powerline adapter C for 3 to 8 seconds. Step 2. Press and hold the Pair button on Powerline adapter A/B for 3 to 8 seconds. (This step must be taken within 120 seconds after step 1 is finished.) Step 3. Wait for about 60 seconds while your Powerline adapters are connecting. The Power LED on Powerline adapter A/B and C will stop flashing and become solid light when the connection is made. ) Note: The sequence of Step 1 and Step 2 can be exchanged. Leave an existing Powerline AV Network: As the figure above shown, Powerline adapter A, B and C have formed a HomeplugAV Network. The user wants to remove one device (Powerline adapter A) from this network. Step 1. Press and hold the Pair button on Powerline adapter A for at least 10 seconds. Powerline adapter A will reset and restart.( The PWR LED of Powerline adapter A will momentarily extinguish during resetting, flash during restarting then illuminate steadily.) Step 2. Wait for the reset to complete. 5.3 Reset To reset the Powerline AV device： Press and hold the Reset button for 3 to 10 seconds, and then release the button. You will see all LEDs begin to flash. At this moment, the default settings have been restored. Be careful, don't power off when the device is in reset process. 25