TP-Link TL-SG5412F TL-SG5412F V1 IG 7106503848
TP-Link TL-SG5412F Manual
 |
View all TP-Link TL-SG5412F manuals
Add to My Manuals
Save this manual to your list of manuals |
TP-Link TL-SG5412F manual content summary:
- TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 1
Enterprise Networking Solution Installation Guide L2 Managed Switch TL-SG5428/TL-SG5412F - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 2
without permission from TP-LINK TECHNOLOGIES CO., LTD. Copyright © 2012 TP-LINK TECHNOLOGIES CO., LTD. All rights reserved. http://www.tp-link.com FCC and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 3
://www.tp-link.com About this Installation Guide This Installation Guide describes the Switch. Chapter 5 Configuration. This chapter instructs you to configure the Switch via Web Interface and CLI commands. Appendix A Troubleshooting. Appendix B Hardware Specifications. Appendix C Technical Support - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 4
Due to the similarity in the structure of the L2 Managed Switch series, in this Installation Guide we take TL-SG5428 as an example to illustrate Chapter 2 Installation, Chapter 3 Lightning Protection and Chapter 4 Connection. This guide uses the specific formats to highlight special messages. The - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 5
15 4.5 Power On 15 4.6 Initialization 16 Chapter 5 Configuration 17 5.1 Configure the Switch via GUI 17 5.2 Configure the Switch Using CLI 18 Appendix A Troubleshooting----------- 22 Appendix B Hardware Specifications------- 23 Appendix C Technical Support---------- 24 Contents IV - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 6
TL-SG5428/TL-SG5412F from TP-LINK provides wire-speed performance and full set of layer 2 management features. It provides a variety of service features and multiple powerful functions with high security. The EIA-standardized framework and smart configuration TP-LINK JetStreamTM L2 Managed Switch - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 7
to the corresponding port LEDs ( for TL-SG5412F ) LED Status PWR On Off/Flashing Flashing SYS On/Off 10/100/1000 BASE-T Green Yellow On Flashing On Flashing Off On 1000Mbps Off On Link/Act Flashing Off Indication The Switch is powered on The Switch is powered off or power supply is - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 8
devices support 1000Mbps SFP module connection only. Each has a corresponding 1000Mbps LED and Link/Act LED. Console Port Designed to connect with the serial port of a computer or terminal for monitoring and configuring the Switch. ■■ Rear Panel Due to the similarity of TL-SG5428 and TL-SG5412F in - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 9
any of the listed items is damaged or missing, please contact your distributor. One Switch One Power Cord, One Console This Installation Guide Cable and one Ground Cable TL-SG5428 One Resource CD TL-SG5428 Two mounting brackets and the fittings 2222Safety Precautions To avoid any device damage - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 10
L2 Managed Switch Please insulation materials and can thus significantly shorten the service life of the device. For normal temperature and RH Non-condensing 5% ~ 90%RH Non-condensing Clearness TL-SG5428 The dust accumulated on the Switch can be absorbed by static electricity and result in poor - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 11
L2 Managed Switch protection measures should be taken. ■■ Ensure the rack and device are well earthed. a rack or a flat workbench, please note the following items:TL-SG5428 ■■ The rack or workbench is flat and stable, and sturdy enough to support the weight of 5.5kg at least. ■■ The rack or workbench - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 12
TL-SG5428 L2 Managed Switch 333 Turnover the device and attach the supplied rubber feet to the Rack Installation To install the device in an EIA standard-sized, 19-inch rack, follow the instructions described below: 111 Check the grounding and stability of the rack. 222 Secure the supplied rack- - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 13
L2 Managed Switch CCCCCCCCCCCLightning Protection 3333 Cabling Reasonably In the actual network environment, you may need cable outdoors and indoors, and the requirements for cabling outdoors and indoors - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 14
L2 Managed Switch ■■ Requirements for the distance between Ethernet cable and other pipelines are shown in the table. Ethernet Cable Other Pipelines Min Parallel Net Length Min Parallel-overlapping Net Height L (mm1 H (mm1 Down-conductor 1000 300 PE 50 20 Service pipe 150 20 - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 15
L2 Managed Switch 3333Connect to Ground Connecting the device to ground is to quickly body from electric shock. In different environments, the device may be grounded differently. The following will instruct you to connect the device to the ground in two ways, connecting to the grounding bar or - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 16
L2 Managed Switch Note: ■■ The figure is to illustrate the application and principle. The power cord you get from the package and the socket in your situation will - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 17
L2 Managed Switch 3333Use Lightning Arrester Power lightning arrester and signal lightning arrester are device and connect it to the ground via a shorter ground cable. TL-SG5428 Grounding Terminal Signal Lightning Arrester Equipotential Bonding Cable Device Ethernet Cable FFFFFFFFFFFFLightning - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 18
as the following figure shown. RJ45 Port TL-SG5428 RJ45 Cable FFFFFFFFFFFFConnecting the RJ45 Port 4444SFP Port Connect the SFP port to a SFP module. For the switch, if an SFP transceiver (purchased separately) is installed in a slot and has a valid link on the port, the associated RJ45 port - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 19
feet. TL-SG5428 and TL-SG5412F are compatible with all kinds of gigabit SFP modules including sigle-mode and multi-mode. The transmission distance and the type of optical fiber are determined by the SFP module you choose. Here you are recommanded to choose the SFP modules produced by TP-LINK, which - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 20
CLI after connecting the PCs or Terminals to the console port on the Switch via the provided cable. Connect the console port of the device with your computer by the console cable as the following figure shown. TL-SG5428 FFFFFFFFFFFFConnecting the Console Port You can also manage the device through - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 21
L2 Managed Switch FFFFFFFFFFFFConnecting to Power Supply Note: The figure is to illustrate the application and principle. The power cord you get from the package and the socket - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 22
subnet addresses of the Switch. The IP address is 192.168.0.x ("x" is any number from 2 to 254), Subnet Mask is 255.255.255.0. For the detailed instructions as to how to do this, please refer to Appendix B in the User Guide on the Resource CD. 222 Enter admin for the default User Name and Password - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 23
L2 Managed Switch 5555Configure the Switch Using CLI You can log on to the Switch and access the CLI by the following two methods: ■■ Log on to the Switch by the console port on the Switch. ■■ Log on to the Switch 444 Select the port to connect in Figure 5-6, and click OK. Configuration 18 - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 24
Type the User name and Password in the Hyper Terminal window, the factory default value for both of them is admin. The DOS prompt" TP-LINK>" will appear after pressing the Enter button as Figure 5-8 shown. It indicates that you can use the CLI now. 19 Configuration FFFFFFFFFFFFLog in the Switch - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 25
L2 Managed Switch ■■ Logon by Telnet To log on to the switch by a Telnet connection, please take the following steps: 111 Make sure the switch and the PC are in the same LAN. 222 Click Start→ shown as Figure 5-11, and press the Enter button. FFFFFFFFFFFFFConnecting to the Switch Configuration 20 - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 26
name and Password (the factory default value for both of them is admin) and press the Enter button, then you can use the CLI now, which is shown as Figure 5-12. FFFFFFFFFFFFFLog in the Switch For detailed CLI configuration instructions, please refer to the CLI Reference Guide on the resource CD. 21 - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 27
the reset command to reset the system. The system will be reset to the factory default settings, and the default login IP address of your PC is set within the subnet of the Switch. 555If you still cannot access the configuration page, please restore the Switch to its factory defaults. Then the IP - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 28
L2 Managed Switch AAAAAAAAAAAAHardware Specifications Item Content IEEE 802.3 10Base 1000Base-X: MMF or SMF SFP Module (Optional1 LEDs PWR, SYS, 1000Mbps, Link/Act, 10/100/1000Mbps BASE-T (for TL-SG5412F only1 Operating Temperature 0℃~40℃ Storage Temperature -40℃~70℃ Operating Humidity 10%~ - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 29
L2 Managed Switch AAAAAAAAAAAATechnical Support ■■ For more help, please go to: http://www.tp-link.com/en/support/faq ■■ To download the latest Firmware, Driver, Utility and User Guide, go to: http://www.tp-link.com/en/support/download ■■ For all other technical support, please contact us by using - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 30
L2 Managed Switch Germany/Austria Switzerland Ukraine Russian Federation Brazil Poland Tel: +49 1805 875465 (German Service) / +49 1805 TPLINK E-mail: [email protected] Fee: 0.14 EUR/min from the German fixed phone network and up to 0.42 EUR/min from mobile phone Service time: Monday to - TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 31
- TP-Link TL-SG5412F | TL-SG5412F V1 IG 7106503848 - Page 32
Website: http://www.tp-link.com Tel: +86 755 26504400 E-mail: [email protected] 7106503848 Rev: 2.0.1
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
 |
 |
Installation Guide
L2 Managed Switch
TL-SG5428/TL-SG5412F
Enterprise Networking Solution