TP-Link TL-SG5412F TL-SG5412F V1 IG 7106503848 - Page 11

Installation Tools, Product Installation

Get TP-Link TL-SG5412F PDF manuals and user guides View all TP-Link TL-SG5412F manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

L2 Managed Switch protection measures should be taken. ■■ Ensure the rack and device are well earthed. ■■ Make sure the power socket has a good contact with the ground. ■■ Keep a reasonable cabling system and avoid induced lightning. ■■ Use the signal SPD (Surge Protective Device) when wiring outdoor. Note: For detailed lightning protection measures, please refer to Chapter 3 Lightning Protection. Installation Site S TL-SG5428 When installing the device on a rack or a flat workbench, please note the following items:TL-SG5428 ■■ The rack or workbench is flat and stable, and sturdy enough to support the weight of 5.5kg at least. ■■ The rack or workbench has a good ventilation system. The equipment room is well ventilated. ■■ The rack is well grounded. Keep the power socket less than 1.5 meters away from the device. 2222Installation Tools ■■ Phillips screwdriver ■■ ESD-preventive wrist wrap ■■ Cables Note: These tools are not provided with our product. If needed, please self purchase them. 2222Product Installation ■■ Desktop Installation To install the device on the desktop, please follow the steps below: 111 Set the device on a flat surface strong enough to support the entire weight of the device with all fittings. 222 Remove the adhesive backing papers from the rubber feet. Installation 06

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
06
L2 Managed Switch
protection measures should be taken.
Ensure the rack and device are well earthed.
■
Make sure the power socket has a good contact with the ground.
■
Keep a reasonable cabling system and avoid induced lightning.
■
Use the signal SPD (Surge Protective Device± when wiring outdoor.
■
Note:
For detailed lightning protection measures, please refer to
Chapter 3
Lightning Protection.
Installation Site
When installing the device on a rack or a flat workbench, please note the following
items:
The rack or workbench is flat and stable, and sturdy enough to support the weight of
■
5.5kg at least.
The rack or workbench has a good ventilation system. The equipment room is well
■
ventilated.
The rack is well grounded. Keep the power socket less than 1.5 meters away from the
■
device.
Installation Tools
³12
Phillips screwdriver
■
ESD-preventive wrist wrap
■
Cables
■
Note:
These tools are not provided with our product. If needed, please self purchase
them.
Product Installation
³1´
Desktop Installation
■
To install the device on the desktop, please follow the steps below:
Set the device on a flat surface strong enough to support the entire weight of the
1.
device with all fittings.
Remove the adhesive backing papers from the rubber feet.
2.
Installation