TP-Link TL-SG5412F TL-SG5412F V1 IG 7106503848 - Page 17
Use Lightning Arrester
View all TP-Link TL-SG5412F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
L2 Managed Switch 3333Use Lightning Arrester Power lightning arrester and signal lightning arrester are used for lighting protection. Power lightning arrester is used for limiting the voltage surge due to a lightning. If an outdoor AC power cord should be directly connected to the device, please use a power lightning arrester. Note: Power lightning arrester is not provided with our product. If needed, please self purchase it. Signal lightning arrester is used to protect RJ45 ports of the device from lightning. When cabling outdoors, please install a signal lightning arrester before connecting the cable to the device. When purchasing or using a signal lightning arrester, please observe the following rules: ■■ The port rate of the signal lightning arrester should match the rate of the desired port on the device. If it is not matched, this signal lighting arrester will not work. Purchase a standard lightning arrester. ■■ Install signal lightning arrester near the protected device and connect it to the ground via a shorter ground cable. TL-SG5428 Grounding Terminal Signal Lightning Arrester Equipotential Bonding Cable Device Ethernet Cable FFFFFFFFFFFFLightning Arrester Connection Note: ■■ Signal lightning arrester is not provided with our product. If needed, please self purchase it. ■■ The SFP ports performe transmission by optical fiber which is immune to electric conduction. Therefore, 3.4 Use Lightning Arrester is not appropriate for SFP ports but only applies to RJ45 ports. Lightning Protection 12