TP-Link TL-WR1043N TL-WR1043NEU V5 User Guide - Page 20
Set Up an IPv6 Internet Connection, PPPoE, Dynamic IPSLAAC/DHCPv6, Static IP, 6to4 tunnel
View all TP-Link TL-WR1043N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Tips: • If your Internet connection type is BigPond Cable, please go to Advanced > Network > Internet to set your router. • If you use Dynamic IP and PPPoE and you are provided with any other parameters that are not required on the page, please go to Advanced > Network > Internet to complete the configuration. • If you still cannot access the Internet, refer to the FAQ for further instructions. 4. 3. Set Up an IPv6 Internet Connection Your ISP provides information about one of the following IPv6 Internet connection types: PPPoE, Dynamic IP(SLAAC/DHCPv6), Static IP, 6to4 tunnel, Pass-Through (Bridge). 1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router. 2. Go to Advanced > IPv6. 3. Enable IPv6 and select the Internet connection type provided by your ISP. Tips: If you do not know what your Internet connection type is, contact your ISP or judge according to the already known information provided by your ISP. 4. Fill in information as required by different connection types. Red blanks must be filled in. 1 ) Static IP: Fill in blanks and click Save. 2 ) Dynamic IP(SLAAC/DHCPv6): Click Advanced to input further information if your ISP requires. Click Save and then click Renew. 17