TP-Link WBS210 WBS210 V1 Installation Guide - Page 6
Connect Cables
 |
View all TP-Link WBS210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Connect Cables 1 Firmly grasp the rear of the interface cover and pull it downward. 2 Use an adequate Ethernet cable to connect the LAN0 (POE IN) port. The length of cable is up to 60m for steady power supply. Shielded CAT5e (or above) cable with an integrated ground wire is recommended. 3 Affix the waterproof rubber insert to the underside of the device for waterproofing and replace the cover until it firmly locks into place. 4 Connect the RF Cables to the Base Station. 4
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13
-
14
-
15
-
16
-
17
-
18
 |
 |
4
Affix the waterproof rubber insert to
the underside of the device for
waterproofing and replace the cover
until it firmly locks into place.
Use an adequate Ethernet cable to
connect the LAN0 (POE IN) port. The
length of cable is up to 60m for
steady power supply. Shielded CAT5e
(or above) cable with an integrated
ground wire is recommended.
2
Connect the RF Cables to the Base
Station.
4
3
Firmly grasp the rear of the interface
cover and pull it downward.
1
Connect Cables