Thermador DWHD650WFP Instructions for Use - Page 15
Rinse Aid
View all Thermador DWHD650WFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Rinse Aid As soon as the low rinse aid indicator 8 lights up on the control panel, rinse aid should be topped off. The rinse aid is required for stain-free utensils and clear glasses. Use only rinse aid which the manufacturer designates as safe to use in domestic dishwashers. Combined detergents with rinse aid component may be used with soft to moderately hard water only (0-2 bands on test strip or up to an °E value of 20). For moderately hard to hard water (3 to 4 bands on test strip or °E value of 21 or higher), rinse aid must be used. Adding rinse aid NOTICE: To avoid oversudsing or clogging, do not overfill the rinse aid dispenser 9*. Wipe up any spills with a damp cloth. 1. Open the rinse aid dispenser 9* by pressing on the latch of the lid and pulling it open. 2. Add liquid rinse aid to the dispenser 9* until it is full. Do not overfill. Avoid spilling into air vent hole. Tip: For easier pouring, remove lid from the rinse aid bottle. NOTICE: Do not fill the rinse aid dispenser 9* with detergent. Doing so will damage the dishwasher. Setting the amount of rinse aid used The amount of rinse aid to be dispensed can be set from §:‹‹ to §:‹‡. Set the amount of rinse aid to be dispensed to §:‹† to obtain a very good drying result. Do not change the amount of rinse aid unless there are streaks or water stains on the utensils. Set a lower level to avoid streaks. Set a higher level to avoid water stains. Set the amount of rinse aid as follows: 1. Open the door. 2. Press on ON/OFF button (. 3. Press the Setup button for 3 seconds until •:‹‹ is shown on the display window H. 4. Keep pressing the Setup button until the rinse aid setting, §:‹† is displayed. 5. Change the setting with the setting buttons + - P. 6. Press and hold the Setup button for 3 seconds. The chosen setting has now been stored. Note: Do not change the amount of rinse aid unless there are streaks (select lower setting) or water stains (select higher setting) visible on the utensils. Turning off rinse aid indicator Proceed as described in the section "Setting the amount of rinse aid used" and set value to §:‹‹. The rinse aid indicator is now turned off. NOTICE: Using no rinse aid or setting the dispenser to §:‹‹ may result in longer cycle times consuming more energy and water. The higher temperatures and longer cycle times can damage fine china or glassware. PD[ BJS WFOU 3. Close the lid. Lid must be fully closed until it clicks in order to seal. 4. Wipe up any excess rinse aid that may have puddled when the dispenser reservoir is full. This prevents excessive frothing during the next wash cycle. The indicator light will go out a few moments after the dishwasher door is shut. 15