Thermador DWHD650WFP Instructions for Use - Page 37
Troubleshooting
View all Thermador DWHD650WFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Troubleshooting Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The following information may help you with a dishwasher problem without involving a repair professional. Note: If the appliance stops during dishwashing or does not start for any obvious reason, first run the cancel wash cycle function (Reset). 9 WARNING IMPROPER REPAIRS OR USE OF NON-ORIGINAL REPLACEMENT PARTS MAY CAUSE CONSIDERABLE DAMAGE AND PUT THE USER AT CONSIDERABLE RISK Always have repairs carried out by authorized technicians. If a component has to be replaced, always use original replacement parts. Error message Some faults are indicated at the top of the display window H and on the front display * ): and possible remedies are offered (for example Filter system soiled (E22) -->Clean filters). * optional feature which may or may not be included with your dishwasher. Fault table Fault Cause Remedial action Error code ":,‰ is lit. Supply hose kinked. Install supply hose without kinks. Tap turned off. Turn on the tap. Tap jammed or calcified. Turn on the tap. Flow rate must be min. 10 l/min. when water supply is open. Error code ":‹ˆ is lit. Intake opening (on right inside of Arrange dishes so that the intake opening is appliance) covered by dishes. not obstructed. Error code ":ƒƒ is lit. Filters 1b are soiled or blocked. Clean filters. Error code ":ƒ... is lit. Waste-water hose kinked or blocked. Install hose without kinks, remove any residue. Siphon connection still sealed. Check connection to siphon and open if required. Cover on the drain pump loose. Lock cover correctly. Error code ":ƒ† is lit. Drain pump blocked or cover on the Clean pump and lock cover correctly. drain pump is not locked in position. Error code ":ƒˆ is lit. Supply voltage too low. Not an appliance fault, have the mains voltage and electrical installation checked. A different error code is indi- A technical fault has probably cated on the digital display. occurred. (":‹, to ":„‹) Switch off appliances with the ON/OFF switch (. After a short time restart the appliance. If the problem recurs, turn off the tap and pull out the mains plug. Call customer service and mention the error code. Refill indicator for salt @ and/or rinse-aid 8 is lit. No rinse aid. No salt. Refill rinse aid. Refill with special salt. Sensor does not detect salt tablets. Use different special salt. Refill indicator for salt @ Refill indicator switched off. and/or rinse-aid 8 is not lit. There is still enough special salt/ rinse aid available. Activation/deactivation. Check refill indicator, levels. Water is left in the appliance Filter system or area under the fil- Clean filters and area underneath. at the end of the wash cycle. ters 1b is blocked. Wash cycle has not ended yet. Wait until wash cycle ends or reset. 37