Thermador PRG305WH Instructions for Use - Page 57
Do-it-yourself maintenance
View all Thermador PRG305WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Do-it-yourself maintenance Oven light bulb replacement 9 CAUTION • Make sure the appliance and lights are cool and power to the appliance has been turned off before replacing the light bulb(s). Failure to do so could result in electrical shock or burns. • The covers must be in place when using the appliance. • The covers serve to protect the light bulb from breaking. • The covers are made of glass. Handle carefully to avoid breaking. Broken glass could cause an injury. • The light socket is live when the door is open. Replace only with a recommended light bulb designed for appliance oven use. DO NOT use a standard household light bulb in any oven. Call Thermador Customer Care Center at 1-800-735-4328 or your nearest Thermador dealer to determine the proper replacement bulb for your range. You will need to know your range's model number and serial number. To replace the light bulb Use only 10W, 12V G4 light bulbs. Use a clean, dry cloth to handle halogen light bulbs. This will increase the life of the bulb. 1. Turn off circuit breaker. 2. Remove the oven racks. 3. Slide the tip of a flat blade screw driver between the holder clip and the lamp housing (figure, a). 4. Support the glass lens cover with fingers along the bottom edge to prevent the cover from falling to the bottom of the oven. Gently twist the flat blade screw driver to loosen the glass lens cover. 5. Remove the glass lens cover. 6. Remove the bulb by grasping and sliding the bulb straight back until the two prongs have cleared the ceramic holder (figure, b). 7. DO NOT touch the glass of the new replacement bulb with your fingers. It may cause the bulb to fail when it first lights. Grasp the replacement bulb with a clean dry cloth. Locate the two prongs in the ceramic holder, gently poking until the two prongs locate in the ceramic socket. 8. Press down to seat the bulb (figure, c). 9. Slide the protective lens into the holder clip and push the other end until the fixing clip snaps back into the housing (figure, d). a b c d 10. Turn on circuit breaker. Page. 55