Toshiba 32BV700B Owners Manual - Page 13

Initial Installation - Digital & Analogue Before switching on the television put your decoder and media recorder to Standby if they are connected and ensure the aerial is connected to your television. To set up the television use the buttons on the remote control as detailed on page 4. 1. Connect the mains plug and switch the TV into standby using the side On/Off switch. Press any numbered or standby button on the remote control, then the language selection menu will be displayed. This screen will appear the first time that the television is switched on and each time the television is reset. 2. By pressing the Up or Down buttons highlight the language you want to set and press OK button. Afterwards, the following message will be displayed on the screen: channels and settings, i.e. locked channels, will be lost. • Select the SETUP from the main menu by using Up or Down buttons. Press OK and Setup menu will be displayed. 3. Select Yes by using Left or Right buttons and press OK to continue. The Auto tuning screen will appear and the television will start to search for available stations. The progress bar will move along the line. You must allow the television to complete the search. 4. After Automatic Search is completed, the following message asking for analogue channel search appears on the screen. Select Yes by using Left or Right buttons and press OK to continue. • Select the Installation from the Setup menu by using Up or Down buttons. Press OK and Installation menu will be displayed. • Select Automatic Channel Scan from the Installation menu by using Up or Down buttons and press OK. A screen will appear warning that previous digital programmes and settings will be deleted. Select Yes and press OK to continue with the Auto tuning. 5. Select your Country, Language and Text language by using navigation buttons. Press OK or RED button to continue. To cancel, press the BLUE button. Note: • For proper functioning of digital teletext in DTV mode, you should set country as UK in analogue AUTO PROGRAM (for UK broadcasts only). • Do not turn off the TV while initializing first time installation. Auto Tuning As new services are broadcast, it will be necessary to re-tune the television in order to view them. • The television will start to search for all available stations.You must allow the television to complete the search. When the search is complete the Auto tuning screen will display the total number of services found. • After search is completed for digital channels, a message asking whether to search for analogue channels appears on the screen: Auto Tuning will completely re-tune the television and can be used to update the channel list. It is recommended that Auto Tuning is run periodically to ensure that all new services are added. All current • Press the OK button to search for analogue channels. The following menu appears on the screen for analogue channel search: English - 12 - 00_MB45M_[GB]_3910UK_IDTV_SILVER8_32740W_(IB_INTERNET)_10068434_v1.indd 12 10.03.2011 14:14:57