Toshiba 50H81 Service Manual - Page 8

Replacement Of The Crt, Lead And Anode Cap. Rubber Boot Is

Get Toshiba 50H81 PDF manuals and user guides View all Toshiba 50H81 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

GENERAL ADJUSTMENTS SPECIFIC INFORMATIONS REPLACEMENT OF THE CRT Service parts are provided for each R, G and B. The contents of the parts are as follows. HITACHI CRT REPLACEMENT OF HIGH VOLTAGE CABLE ANODE LEAD RUBBER BOOT LEAD HOLDER R 23008174 G 23008175 B 23008176 1. When replacing Anode Lead or Anode Cap with new one, remove Lead Holder from old lead as shown in figure below, and put it on new lead. Do not throw away Lead Holder. NOTE : THE LEAD HOLDER IS ATTACHEDTO TPA5007 (Z450), BUT IS NOT ATTACHED TO ANODE LEAD AND ANODE CAP. RUBBER BOOT IS ATTACHED TO ANODE LEAD AND ANODE CAP. 2. Detaching Lead Holder OLD RUBBER BOOT ANODE LEAD or ANODE CAP Fig. a Z450 TPA5007 LOCK LEAD HOLDER Cut here rubber boot and lead together to detach Lead Holder. Fig. b - 8 -

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
– 8 –
GENERAL ADJUSTMENTS
SPECIFIC INFORMATIONS
REPLACEMENT OF THE CRT
Service parts are provided for each R, G and B.
The contents of the parts are as follows.
R
G
B
HITACHI
CRT
23008174
23008175
23008176
REPLACEMENT OF HIGH VOLTAGE CABLE
ANODE LEAD
RUBBER BOOT
LEAD HOLDER
Z450 TPA5007
Fig. a
1.
When replacing Anode Lead or Anode Cap with new one,
remove Lead Holder from old lead as shown in figure
below, and put it on new lead. Do not throw away Lead
Holder.
NOTE :
THE LEAD HOLDER IS ATTACHED TO TPA5007
(Z450), BUT IS NOT ATTACHED TO ANODE
LEAD AND ANODE CAP. RUBBER BOOT IS AT-
TACHED TO ANODE LEAD AND ANODE CAP.
2.
Detaching Lead Holder
Fig. b
RUBBER BOOT
OLD
ANODE LEAD
or
ANODE CAP
LOCK
LEAD HOLDER
Cut here rubber boot
and lead together to
detach Lead Holder.