Toshiba A300 PSAGDA-03D00R Users Manual AU/NZ - Page 162

Power and Power-up Modes Starting the computer by password If you have already registered a password, there are two ways to start the computer: ■ Swipe your fingerprint on the sensor if you have already registered the fingerprint with the Fingerprint utility and enabled Fingerprint Power-on Security. If you would not like to swipe your finger or cannot authenticate the fingerprint for some reasons, press the ESC key or click Switch User button to skip the fingerprint authentication screen. You can try to swipe the fingerprint up to five times. If you failed fingerprint authentication more than five times, you must enter the password manually to start the computer. ■ Enter the password manually. To start up the computer with the user password, follow these steps: 1. Turn on the power as described in Chapter 3, Getting Started. The fol- lowing message appears: Enter Current Password At this point, the hot keys FN + F1 to F9 do not work. They will function after you enter the password. 2. Enter the password. 3. Press ENTER. If you enter the password incorrectly three times in a row, the computer shuts off. In this case, you must turn the computer back on to retry password entry. Power-up modes The computer has the following power-up modes: ■ Boot: Computer shuts down without saving data. Always save your work before you turn the computer off in boot mode. ■ Hibernation: Data in memory is saved to the hard disk. ■ Sleep: Data is maintained in the computer's main memory. Refer also to the sections Turning on the power and Turning off the power in Chapter 3, Getting Started. Windows utilities You can specify the setting in Power Options. Hot keys You can use hot keys FN + F3 to enter sleep mode and FN + F4 to enter hibernation mode. See Chapter 5, The Keyboard for details. User's Manual 6-13