Toshiba TDP-S1-US User Guide - Page 15
Heading2 - Turning Off the Projector, onds for the projection lamp to reach full power and project
View all Toshiba TDP-S1-US manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Turning Off the Projector If you want to turn off the projector for a short period of time, press the standby button on the keypad. This blanks the screen for fifteen minutes, but keeps the projector running. (You can change the amount of time the projector stays in standby mode; see "Standby Time" on page 23 for details.) After 15 minutes, the lamp goes out (the projector keeps running). To exit standby mode, press the standby button again. (It may take several seconds for the projection lamp to reach full power and project the image again.) To completely power off the projector, press the "O" side of the power switch on the side of the projector. If you want to turn the projector back on immediately, you must allow about a minute for the lamp to cool. The lamp won't light if it's too hot. CAUTION: When you disconnect the projector after you have switched it off, always remove the power cord from the electrical outlet first, then remove it from the projector. 11