Tripp Lite 9PX6KL Eaton 9PX 6KVA Lithium-Ion Advanced Users Guide 9PX6K-L 9PXE - Page 21
Removal of the Battery Pack
View all Tripp Lite 9PX6KL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Figure 8. Removal of the Battery Pack 9PX 6000 Li-ion 1 2 Rack Installation 3 4 5 6 To remove the battery pack: 1. Remove the center cover of the front panel. 2. Remove the two screws to open the left side of the front panel. 3. Disconnect the BMS battery connector. A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable or disconnect it. 4. Remove the two screws that hold the metal protection cover in place. 5. Carefully guide the BMS cable through the hole in the metal protection cover and remove. 6. Pull out the handle of the battery pack, and slide the pack out slowly on to a flat and stable surface. Use two hands to support the battery pack. Installing the UPS on the Rails Follow steps 1 to 5 for module mounting on the rails. Eaton 9PX Lithium-Ion User Guide DPD-9PX2206-Rev 01 15