Tripp Lite B0930082E4UV Owners Manual for B093- B097- and B098-Series Console - Page 131
Check Conditions
View all Tripp Lite B0930082E4UV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
7. Alerts, Auto-Response and Logging 7.2 Check Conditions To configure the condition that will trigger the auto-response: • Click on the Check Condition type (e.g. Environmental, UPS Status or ICMP ping) to be configured as the trigger for this new auto-response in the Auto-Response Settings menu. 7.2.1 Environmental To configure humidity or temperature levels as the trigger event: • Click on Environmental as the Check Condition. • In the Environmental Check menu, select the specific Environmental Sensor to be checked for the trigger. • Specify the Trigger value (in °C / °F for Temp and % for Humidity) that the check measurement must exceed or drop below to trigger the auto-response. • Select Comparison type as being Above Trigger Value or Below Trigger Value to trigger. • Specify any Hysteresis factor that is to be applied to environmental measurements (e.g., if an Auto-Response was set up with a trigger event of a temp reading above 49°C with a Hysteresis of 4, then the trigger condition would not be seen as having been resolved until the temp reading was below 45°C) . • Check Save Auto-Response. Note: Before configuring environmental checks as the trigger in auto-response, you will need first to configure the temperature and/or humidity sensors on your attached EMD. 7.2.2 Alarms and Digital Inputs To set the status of any attached smoke or water sensors or digital inputs as the trigger event: • Click on Alarms / Digital Inputs as the Check Condition. • In the Alarms / Digital Inputs Check menu, select the specific Alarm/Digital IO Pin that will trigger the Auto-Response. • Select Trigger on Change to trigger when alarm signal changes, or select to trigger when the alarm signal state changes to either a Trigger Value of Open (0) or Closed (1). • Check Save Auto-Response. Note: Before configuring Alarms / Digital Inputs checks in Auto-Response, you first must configure the sensor/DIO that is to be attached to your EMD. 131