URC MX-450 Programming Guide - Page 24
IR/RF signal, RF ID, Emitter, Blaster
View all URC MX-450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
IR/RF signal Advanced Setup RF Setup 9 To use a RF base station, the following options should be addressed: IR or RF Signal: Turn OFF IR Signal (no need to point) and turn ON RF Signal (communicates with base station.) RF ID# (Address): Select an ID# between 1-F. The ID# identifies the base station to the remote. It is important to select the same # on the RF base station. DO NOT SELECT ID# 0, as any RF remote can control the base station. See next slide for further information. Emitter (IR) Routing: Select an individual emitter number, by pressing the UP or DOWN soft buttons, for each device selected. If All devices were selected leave as All lines. Blaster On/Off: Decide whether the front-facing IR "blaster" should be ON or OFF. The Blaster On option blasts the IR signal from the front of the RF base station. Press Save for each modified option. RF ID Emitter Blaster