Uniden DCT5260 English Owners Manual - Page 52

3) On the receiving handset, to answer the call, press talk/flash, intercom/hold, or the ANSWER soft key. If you set the AutoTalk On, pick up the handset from the cradle. If Anykey Answer is On, press any number key, /tone/t, or #/s. 4) To finish the intercom call, press the end key or the END soft key on either handset. Call Transfer Feature 1) During a call, press intercom/hold. 2) Select a handset to transfer the call within 10 seconds. H o l d , t o t r a n s f e r (Refer to step 2 in the intercom section on page 49). H a n d s e t # 2 The call will automatically be placed on hold, and an Handset #3 intercom tone sounds. BACK BACK OK To cancel the transfer, press talk/flash or speaker on the initiating handset. 3) On the receiving handset, to answer the page, press talk/flash, intercom/hold, or the ANSWER soft key. If you set the AutoTalk On, pick up the handset from the cradle. If Anykey Answer is On, press any number key, /tone/t, or #/s. The intercom mode is activated, but the caller is still on hold. 4) To transfer the call, press the end key or the END soft key on the initiating handset, and press talk/flash or speaker on the receiving handset. Replacing the Base When you replace the base with a different base of the DCT series model (DCT5260, DCT5280, or DCT5285 series), you need to clear the handset(s) and base ID. To do this, perform the "System Reset" menu options ("De-register the Handset" and "Replacing the Base Setting") (see page 25), then register all the handsets you have (see page 47). [ 50 ] E X PA N D I N G Y O U R P H O N E