Uniden MHS550 English Owners Manual - Page 15
Scan mode operation, Using the radio in scan mode
UPC - 050633500972
View all Uniden MHS550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Scan mode operation You can save channels into memory and then use scan mode to monitor those channels from lowest to highest. If the radio detects a signal on a channel, it stays on that channel as long as the signal is received; when the signal stops, the radio continues scanning. When it detects a signal, the radio stays on the channel until you press the CHANNEL UP button or the signal stops. Resume scan 08 10 11 12 13 14 15 17 20 The radio scans about 5 channels in 0.5 seconds. Using the radio in scan mode • To activate scan mode, press SCAN-MEM. • You cannot transmit while in scan mode. • You must have at least two channels in memory to start a scan. • To save a channel into memory, select the channel, then press and hold the SCAN-MEM button for two seconds. Memory shows on the display whenever you tune to that channel. • To remove a channel from memory, set the radio to that channel, then press and hold the SCAN-MEM button for two seconds. Memory no longer shows on the display. • When the radio stays on a channel, press CHANNEL UP to leave that channel and resume scanning. • To end the scan, press the SCAN-MEM button again; the radio remains on the last scanned channel. Uniden MHS550 Radio Owner's Manual 13