Viking RVER3301 Installation Instructions - Page 18
Eyelet Connection, Bare Wire Connection
![]() |
View all Viking RVER3301 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Electrical Connection (4-wire) (cont.) Bare Wire Connection Eyelet Connection 4 1 1 To make a bare wire connection, use holes on the left side of the terminal block. To connect eyelet style wires, use holes on right side of terminal. 5 Feed supply cord up through hole in bottom of range back. 6 1 2 Attach ground wire (green) with ground screw that was removed. 7 1 1 2 Attach line #1 (black) and line #2 (red) leads to outside terminal. Attach neutral wire (white) to center terminal on terminal block. 8 1 3 Push supply cord toward terminal block to relieve strain, reattach supply cord strain relief bracket over supply cord. 18 2 Reattach access door.
![](/manual_guide/products/viking-rver3301-installation-instructions-56f07cb/18.png)
18
4
Feed supply cord up through hole in bottom
of range back.
1
2
5
1
2
6
Attach ground wire (green)
with ground screw that was removed.
Attach line #1 (black) and line #2 (red)
leads to outside terminal. Attach neutral wire (white)
to center terminal on terminal block.
1
3
7
1
2
8
Push supply cord toward terminal
block to relieve strain, reattach supply cord strain
relief bracket over supply cord.
Reattach access door.
1
1
Eyelet Connection
Bare Wire Connection
To make a bare wire connection, use holes on the left
side of the terminal block. To connect eyelet style
wires, use holes on right side of terminal.
Electrical Connection (4-wire)
(cont.)