Viking VRT LP/Propane Conversion Kit - LPKPDR - Installation Instructions - Page 14
Straight Tube Burner with Glow Bar Ignition
![]() |
View all Viking VRT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Griddle Conversion (for models equipped with griddle) Straight Tube Burner with Glow Bar Ignition Screw (Rear of Burner) Screw (Front of Burner) Adjustment Screw Air Shutter Remove screws securing glow bar igniter to burner box and place glow bar igniter aside. Remove screws securing metal plate to burner box located underneath griddle burner and remove metal plate. Remove screws securing griddle burner to unit and remove griddle burner. Loosen air shutter screw and adjust opening on burner to 7/16" and tighten air shutter screw. Use a 1/2" deep socket wrench to remove orifice by turning counterclockwise. IMPORTANT: If a valve pin is present, remove valve pin and discard. Install orifice from bag labeled Griddle Orifice. NOTE: If necessary, repeat steps for 2nd burner located on 24" griddles. Reverse procedures as needed to reassemble. 14
![](/manual_guide/products/viking-vdr530-lppropane-conversion-kit-lpkpdr-installation-instructions-cf918f9/14.png)