Viking VRT LP/Propane Conversion Kit - LPKPDR - Installation Instructions - Page 7

Surface Burner Conversion

Get Viking VRT PDF manuals and user guides View all Viking VRT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Surface Burner Conversion Sealed Type 1 Item #1 Item #2 Locate bag labeled Sealed Burner Orifice Type 1. Remove the venturi (Item #1) by turning counterclockwise. Use a 11/32" (9 mm) socket or nut driver to remove orifice (Item #2) and replace it with orifice from bag labeled Sealed Burner Orifice Type 1. Tech Tip: Tape can be applied to the inside of a socket to assist in retrieval of the surface burner orifices. This can prevent the orifices from falling into the range during removal. Replace the venturi (Item #1) and hand tighten. Repeat steps until all top burners have been converted. Reverse procedure as needed to reassemble. IMPORTANT: For proper placement of burner head, rotate until burner head seats into groove. For models with an arrow on the burner head, position arrow toward igniter. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
7
Surface Burner Conversion
Sealed
Type 1
Item #1
Item #2
Locate bag labeled Sealed Burner Orifice Type 1.
Remove the venturi (Item #1) by turning counterclockwise.
Use a 11/32” (9 mm) socket or nut driver to remove orifice (Item #2) and replace it with orifice from
bag labeled Sealed Burner Orifice Type 1.
Tech Tip:
Tape can be applied to the inside of a socket to assist in retrieval of the surface burner
orifices. This can prevent the orifices from falling into the range during removal.
Replace the venturi (Item #1) and hand tighten.
Repeat steps until all top burners have been converted.
Reverse procedure as needed to reassemble.
IMPORTANT: For proper placement of burner head, rotate until burner head seats into groove.
For models with an arrow on the burner head, position arrow toward igniter.