Viking VRT LP/Propane Conversion Kit - LPKPDR - Installation Instructions - Page 8
Sealed, Type 2
View all Viking VRT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Surface Burner Conversion Sealed Type 2 Item #1 Item #2 Item #3 Locate bag labeled Sealed Burner Orifice Type 2. NOTE: If the burner is a PowerPlus™ Burner (check control panel), use orifice kit 011915-000 to convert this burner only. WARNING DO NOT use this orifice for any other top burners. Remove the screws (Item #1) and set burner base aside (Item #2). IMPORTANT: Burner bases must be handled carefully to prevent igniter wires from becoming disconnected. Loose igniter wires may fall through top assembly. Use a Metric size 7mm socket or nut driver to remove orifice (Item #3) and replace it with orifice from bag labeled Sealed Burner Orifice Type 2. Tech Tip: Tape can be applied to the inside of a socket to assist in retrieval of the surface burner orifices. This can prevent the orifices from falling into the range during removal. Reverse procedure as needed to reassemble. IMPORTANT: For proper placement of burner head, rotate until burner head seats into groove. For models with an arrow on the burner head, position arrow toward igniter. 8