Viper 5002 Owner Manual - Page 22

Illumination On/Off, notification, To exit programming mode - remote start programming

Get Viper 5002 PDF manuals and user guides View all Viper 5002 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

➜ Illumination On/Off Press to select LCD backlight illumination On/Off. The LCD backlight will illuminate when a remote button is pressed, or an alarm status page is received. LCD Backlight settings Programming response ON 1-beep, backlight ON OFF 2-beeps, backlight OFF ➜ Page notification The remote control can be programmed to notify the user of a page (audibly beeping if the vehicle's status changes, e.g. door unlocked, engine started, vehicle violation, etc.). On the LCD remote press to select page On/Off. One beep is page On, Two beeps is page Off. When programmed off the remote will not give any notification that a page was received from the vehicle. Note: If programmed Off, no alarms will be notified to the remote. Command information (armed/disarmed) will be notified to the remote. ➜ To exit programming mode The LCD remote control will exit programming mode after 5seconds of inactivity and will emit 2 long beep. © 2006 directed electronics 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
17
© 2006 directed electronics
Illumination On/Off
Press
to select LCD backlight illumination On/Off. The
LCD backlight will illuminate when a remote button is pressed,
or an alarm status page is received.
Page notification
The remote control can be programmed to notify the user of a
page (audibly beeping if the vehicle’s status changes, e.g. door
unlocked, engine started, vehicle violation, etc.). On the LCD
remote press
to select page On/Off. One beep is page On,
Two beeps is page Off. When programmed off the remote will not
give any notification that a page was received from the vehicle.
Note:
If programmed Off,
no alarms
will be notified to the
remote. Command information (armed/disarmed) will be noti-
fied to the remote.
To exit programming mode
The LCD remote control will exit programming mode after 5-
seconds of inactivity and will emit 2 long beep.
➜
➜
LCD Backlight settings
Programming response
ON
1-beep, backlight ON
OFF
2-beeps, backlight OFF
➜