Viper 5104 Owner Manual - Page 22

Sensor Warn-away output When the system sensors detect a Warn-away trigger the siren chirps and parking lights flash for 3 seconds. Full Trigger output An alarm Full Trigger will sound the siren and flash the parking lights for 30 seconds. Emergency Override The following procedure disarms the system when a programmed remote is not available. Number of presses__________ 1. Turn the ignition On. 2. Press the control button on the Control Center the correct number of times (the default is 1 press). 3. After a few seconds the siren output ceases and the system is disarmed. Note As a precaution, if programmed for Passive Arming or Auto re-arming the system should be placed into Valet Mode until a remote is available . Trigger Zone Fault Report When armed by remote command the system runs a status check of the alarm trigger zones. Faulty zones (usually caused by dome light delay or open trunk) are bypassed and reported via the control center LED, while all other trigger zones remain active and are monitored to protect the vehicle. Should a faulty zone self correct (dome light turns off) it becomes active and is then monitored normally. The siren chirps once again a few seconds following the arming chirps as an audible alert, the control center LED flashes in groups to indicate the zone number. © 2010 Directed Electronics. All rights reserved. 19