Viper 5104 Owner Manual - Page 32

Battery Information

Get Viper 5104 PDF manuals and user guides View all Viper 5104 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Battery Information The remote controls are powered by 1 coin cell battery (CR-2032) that can be purchased at most retailers. When the battery begins to weaken, the operating range will be reduced. The information and precautions in this section can help maximize your battery's life and usage in providing you with many years of trouble free operation. Low Battery Alerts When disarming the system using a remote with a low battery the siren will emit one additional chirp as an alert. If confirmation chirps are programmed off, the system will still emit one chirp as an alert when disarming. Battery Replacement 1. Using a small flat-head screwdriver, insert into slot located at the bottom of the keypad and carefully pry the front of the unit open. 2. Turn both the unit front and circuit board over, remove battery from clip and replace. © 2010 Directed Electronics. All rights reserved. + + 29

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
29
© 2010 Directed Electronics. All rights reserved.
Battery Information
The remote controls are powered by 1 coin cell battery (CR-2032)
that can be purchased at most retailers. When the battery begins to
weaken, the operating range will be reduced. The information and
precautions in this section can help maximize your battery’s life and
usage in providing you with many years of trouble free operation.
Low Battery Alerts
When disarming the system using a remote with a low battery the
siren will emit one additional chirp as an alert. If confirmation chirps
are programmed off, the system will still emit one chirp as an alert
when disarming.
Battery Replacement
1.
Using a small
flat-head screwdriver,
insert into slot located
at the bottom of the
keypad and carefully
pry the front of the unit
open.
2.
Turn both the
unit front and circuit
board over, remove
battery from clip and
replace.
+
+