Viper 5104 Owner Manual - Page 30

Valet Mode Valet mode can be entered and exited by performing the Remote Valet command or manually using the vehicle key and the control button. When entered, the alarm functions are defeated while the convenience features still operate normally. Use the following steps to manually enter and exit Valet Mode: 1. Turn the ignition switch On and then Off 2. Immediately press and release the control button once 3. The control center LED turns On when entering and Off when exiting. Power Save To reduce power consumption the control center status LED modifies its output if the vehicle is parked for an extended period. If Armed the flashing is reduced after 24 hours. When Valet mode is On the LED turns off after 1 hour and resets each time the ignition is turned off. Rapid Resume If power is ever disconnected by a mechanic or thief, the system will resume the state it was in at the time of disconnection, when power is reconnected. Car Select Car 2 remote control option must first be turned On (See Remote Control Configuration section to turn on). Press and hold the button for 3 seconds. The LED flashes once or twice to indicate the selected Car is 1 or 2, release the button for Car Select or continue to hold for programming. Release the button, then press and release while the LED flashes continue to perform Car Select. Once the car is selected a command can be performed by pressing one of the command buttons. © 2010 Directed Electronics. All rights reserved. 27