Viper 771XV Owner Manual - Page 24

and know where the Valet button is located. Be sure to check with your installer at the time of installation for both the location and the preset response (1-5 presses) of the Valet button. To disarm the security system, turn the ignition to the ON position. Press and release the Valet button the preset number of times DRW-35 (one to five times) within 15 seconds. After five seconds, the system will disarm. If the system does not disarm, you may have waited too long; turn the ignition Off and On and try again. Location of Valet Button Number of Presses important! The Valet® button can be programmed to respond to 1-5 presses for the disarm function. You must check with the installer to verify the programming for your individual unit. The remote will indicate disarm notification with 2 beeps and 3 flashes of the Orange LED. ➜ silent mode To temporarily turn off the vehicle's arm or disarm chirps, use Silent Mode™. Simply press for less than 1-second before arming or disarming, and the confirmation chirp(s) will be eliminated for that one operation only. If you want the arm/disarm chirps turned off permanently, your dealer can do this for you. © 2005 directed electronics-all rights reserved 21