Viper VSS5000 Owner Manual - Page 14

lowed by a long chirp. Zone 2 is now bypassed. Press a third time within five seconds. The siren chirps three times followed by a long chirp. Zone 4 is now bypassed. Press a fourth time within five seconds. The siren chirps four times followed by a long chirp. Zones 2 and 4 are now bypassed. Press a fifth time within five seconds. The siren chirps five times followed by a long chirp. All input zones, except the ignition are now bypassed. Note: Multi-level security arming only applies to a single arming cycle. Once the system is disarmed and then re-armed, all the zones will be active again. Arming while driving Your security system can be armed while driving the vehicle. Press on the remote control for two seconds while the vehicle is running. The siren/horn will sound once to indicate that the security system is armed, and then once more to indicate that the ignition is on. The system will not respond to any input except the door triggers, and the starter kill relay (if installed) will not be activated. Once you have arrived at your destination, the system will disarm when the ignition is turned off. The siren/horn will sound twice and the LED will then stop flashing. The system can also be disarmed at any time by pressing High security disarm This security system offers High Security Disarm. High Security Disarm is a feature that makes it possible to silence and reset the system while it is triggering, without disarming the system. 10 © 2010 Directed Electronics. All rights reserved.