Viper VSS5000 Owner Manual - Page 16

Valet mode You can prevent your system from automatically arming/locking and triggering by using Valet Mode. This is very useful when washing the vehicle or having it serviced. In Valet Mode, the system/starter kill will not arm/enable, even with the remote control, but all convenience functions (door locks, trunk release, etc.) will continue to work normally. To enter or exit Valet Mode: 1. Turn the ignition on. 2. Turn the ignition off. 3. Press and release the control center button within 10 seconds. To enter or exit Valet Mode using the remote control: 4. Open any vehicle door. 5. Press . 6. Press and then press again. The status LED lights solidly if you are entering Valet Mode, and goes off when you exit Valet Mode. Panic Mode if you are threatened in or near your vehicle, you can attract attention by triggering the system with your remote control. Press and hold for two seconds. The siren sounds and the parking lights flash for the programmed siren duration. To stop panic made at any time, press on the remote control again. Remote start This feature allows you to remotely start and run your vehicle for a programmable period of time. This makes it possible to warm up the engine, as well as adjust the interior temperature of the vehicle with 12 © 2010 Directed Electronics. All rights reserved.