Vivitar DVR 426HD v2 Camera Manual - Page 6
Powering the Digital Video Recorder - model
View all Vivitar DVR 426HD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
When powering the camcorder ON for the first time the camcorder will take you through the initial setup. Powering the Digital Video Recorder ON 1) Batteries Make sure the batteries have been inserted properly into your digital video recorder. Slide the battery cover on the back of the camera in a downward direction to open the cover. Insert 3 x AAA (1.5V) batteries (not included) with the correct polarity, according to the polarity illustrated inside the battery compartment. Note: Alkaline batteries are recommended. Remove the batteries from the camera when not in use for an extended period. Do not mix alkaline and non-alkaline batteries. Some camera features (such as Flash in some models) will not work if the battery power level is low. When the battery power is low the battery icon turns red and the camcorder will automatically turn off a few seconds later. The energy status of the power is displayed on LCD as shown below: Full battery power Medium battery power Low battery power 2) SD Memory Card Make sure the camcorder is powered OFF before inserting your SD/MMC/SDHC Memory Card. Make sure an SD card (up to16GB) has been inserted into your digital video recorder. (SD Memory card not included.) To properly insert the SD Card: Push the SD card into the slot in the direction shown on the camcorder (see SD icon by the SD card slot). Push the SD card until you hear a slight clicking sound. This indicates the SD card has been inserted correctly. Note: After the camcorder is powered on, an SD icon will appear on the LCD display. If you do not see the SD icon on the display, please check if the card was inserted properly. 5