Vtech LS6126-5 User Manual - Page 67

FCC, ACTA and IC regulations

Get Vtech LS6126-5 PDF manuals and user guides View all Vtech LS6126-5 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 67 highlights

FCC, ACTA and IC regulations FCC Part 15 This equipment has been tested and found to comply with the requirements for a Class B digital device under Part 15 of the Federal Communications Commission (FCC) rules. These requirements are intended to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this telephone. To ensure safety of users, the FCC has established criteria for the amount of radio frequency energy that can be safely absorbed by a user or bystander according to the intended usage of the product. This product has been tested and found to comply with the FCC criteria. The handset may be safely held against the ear of the user. The telephone base shall be installed and used such that parts of the user's body other than the hands are maintained at a distance of approximately 20 cm (8 inches) or more. If you choose to use a clipping device, please make sure to only use the supplied VTech belt clip. This Class B digital apparatus complies with Canadian ICES-003. FCC Part 68 and ACTA This equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the Administrative Council for Terminal Attachments (ACTA). The label on the back or bottom of this equipment contains, among other things, a product identifier in the format US: AAAEQ##TXXXX. This identifier must be provided to your local telephone company upon request. The plug and jack used to connect this equipment to premises wiring and the telephone network must comply with applicable Part 68 rules and technical requirements adopted by ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is also compliant. An RJ11 jack should normally be used for connecting to a single line and an 64 www.vtechphones.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
www.vtechphones.com
64
FCC, ACTA and IC regulations
FCC Part 15
Th±s equ±pment has been tested and found to comply w±th the requ±rements for a Class B d±g±tal dev±ce under Part 15 of the Federal
Commun±cat±ons Comm±ss±on (FCC) rules. These requ±rements are ±ntended to prov±de reasonable protect±on aga±nst harmful ±nterference ±n
a res±dent±al ±nstallat±on. Th±s equ±pment generates, uses and can rad±ate rad±o frequency energy and, ±f not ±nstalled and used ±n accordance
w±th the ±nstruct±ons, may cause harmful ±nterference to rad±o commun±cat±ons. However, there ±s no guarantee that ±nterference w±ll not occur
±n a part±cular ±nstallat±on. If th±s equ±pment does cause harmful ±nterference to rad±o or telev±s±on recept±on, wh±ch can be determ±ned by turn±ng
the equ±pment off and on, the user ±s encouraged to try to correct the ±nterference by one or more of the follow±ng measures:
Reor±ent or relocate the rece±v±ng antenna.
Increase the separat±on between the equ±pment and rece±ver.
Connect the equ±pment ±nto an outlet on a c±rcu±t d±fferent from that to wh±ch the rece±ver ±s connected.
Consult the dealer or an exper±enced rad±o/TV techn±c±an for help.
Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equ±pment.
Th±s dev±ce compl±es w±th Part 15 of the FCC rules.
Operat±on ±s subject to the follow±ng two cond±t±ons: (1) th±s dev±ce may not cause harmful
±nterference, and (2) th±s dev±ce must accept any ±nterference rece±ved, ±nclud±ng ±nterference that may cause undes±red operat±on. Pr±vacy
of commun±cat±ons may not be ensured when us±ng th±s telephone.
To ensure safety of users, the FCC has establ±shed cr±ter±a for the amount of rad±o frequency energy that can be safely absorbed by a user or
bystander accord±ng to the ±ntended usage of the product. Th±s product has been tested and found to comply w±th the FCC cr±ter±a. The handset
may be safely held aga±nst the ear of the user. The telephone base shall be ±nstalled and used such that parts of the user’s body other than
the hands are ma±nta±ned at a d±stance of approx±mately 20 cm (8 ±nches) or more. If you choose to use a cl±pp±ng dev±ce, please make sure to
only use the suppl±ed VTech belt cl±p.
Th±s Class B d±g±tal apparatus compl±es w±th Canad±an ICES-003.
FCC Part 68 and ACTA
Th±s equ±pment compl±es w±th Part 68 of the FCC rules and w±th techn±cal requ±rements adopted by the Adm±n±strat±ve Counc±l for Term±nal
Attachments (ACTA). The label on the back or bottom of this equipment contains, among other things, a product identifier in the format US:
AAAEQ##TXXXX. This identifier must be provided to your local telephone company upon request.
The plug and jack used to connect th±s equ±pment to prem±ses w±r±ng and the telephone network must comply w±th appl±cable Part 68 rules
and techn±cal requ±rements adopted by ACTA. A compl±ant telephone cord and modular plug ±s prov±ded w±th th±s product. It ±s des±gned to be
connected to a compat±ble modular jack that ±s also compl±ant. An RJ11 jack should normally be used for connect±ng to a s±ngle l±ne and an
•
•
•
•