Waring WIH400 Instruction Manual - Page 7

Do not immerse completely in water to clean. The appliance is not to be cleaned with a water jet. NOTE: The cooking surface will be hot after use. Use caution when handling cooking utensils and cookware. Any other servicing should be performed by an authorized service representative. TROUBLESHOOTING Error Code List on LCD Display Error Code "----" and the unit beeps E1 E2 E3, E5 Description of Error Solutions There is no cookware, empty cookware or no suitable cookware on the range. The power will completely shut off within 60 seconds if there is no cookware or the wrong type of cookware on the unit. • Make sure your pot/pan is induction ready. • Check diameter of pot/pan; it must have a flat bottom between 4.75" and 10" in diameter. WIH400-Voltage is under 78V. Check electrical specifications of power source. WIH400B- Voltage is under 145V. WIH400-Voltage is over 145V. WIH400B- Voltage is over 275V. The heater is damaged. Contact the nearest authorized service facility for troubleshooting, repair and adjustment. E6 The thermal protection has shut Unplug the unit and let cool for the unit off due to overheating in 20 minutes. Plug the unit back in the TEMP mode. and continue use. NOTE: When cooking in HEAT mode, the maximum temperature is 300˚F. To cook at temperatures between 300˚F - 500˚F, use HEAT mode. E7 The temperature inside the unit Unplug the unit and let cool for is too hot. 20 minutes. Once the unit is completely cooled, be sure it is positioned away from the wall and that there are no obstructions to the airflow. Plug the unit back in and continue use. E9 NTC (Overheat Protection Unplug the unit and let cool for Sensor) has been activated or 20 minutes. Plug the unit back triggered. in and continue use. 7