Weber Summit FT 600 LP Owners Manual - Page 15
Step 9, Bolt back panel and back top frame rail, assembly
View all Weber Summit FT 600 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Step 9 Bolt back panel and back top frame rail assembly You will need: back panel, two nylon washers, two 1/4-20 x 1/2 inch bolts and frame assembly. Position back panel cut outs to the top and the flanges to inside of the frame assembly. Figure 11 (a). Flange (a) Caster frame Cut out Align hole of back panel and wheel frame and tab of top frame rail assembly. Slip washer over bolt and start bolt. Figure 12 (a). Note: If there are no threads for the bolt to thread into: a) you may not have the holes of the back panel, frame, and top frame rail tab aligned. b) the tabs of the top rail may not be to the inside of the cart. Refer to Figure 9. Repeat with second bolt aligning back panel and hole in caster frame and tab of top frame rail assembly. Slip washer and start bolt. Tighten both bolts with 7/16 or adjustable wrench. (a) Figure 11 Wheel frame Figure 12 15