Weider 3550 User Manual - Page 18

44. Wrap the VKR Low Cable (72) over a 3 1/2" Pulley (78). Attach the Pulley and a Cable Trap (68) 44 between the lower set of holes in the "U"-bracket (64) with a 3/8" x 2" Bolt (100) and a 3/8" Nylon Locknut (87). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley. 100 64 68 72 87 78 45. Attach the end of the VKR Low Cable (72) inside of 45 the Short Base (2) with a 5/16" x 2 1/2" Bolt (59), two 5/16" Washers (90), and a 5/16" Nylon Locknut (86). 46. Locate the Squat Cable (73), which is the only remaining cable. Attach the eyelet end of the Cable inside of the Long Base (120) with a 5/16" x 2 1/2" Bolt (59), two 5/16" Washers (90), and a 5/16" Nylon Locknut (86). 72 86 90 2 90 59 46 90 59 73 86 90 120 47. Wrap the Squat Cable (73) over a 3 1/2" Pulley 47 (78). Attach the Pulley, a Cable Trap (68), and two 3/4" Spacers (124) between the indicated brackets on the Squat Slider (38) with a 3/8" x 3 1/4" Bolt (96) and a 3/8" Nylon Jamnut (113). Make sure that the Cable Trap is turned to hold the Cable in the groove of the Pulley. 73 78 68 124 124 96 113 38 18