Weider 900 Uk Manual - Page 11
the Nylon Locknut; the Weight Tube must
View all Weider 900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
14. Attach the end of the High Cable (50) to the 14 Small "U"-bracket (11) with an M8 Washer (71) and an M8 Nylon Locknut (69). Note: Do not completely tighten the Nylon Locknut; it should be threaded onto the Cable so that two threads show past the Nylon Locknut, as shown in the inset drawing. Attach the Small "U"-bracket (11) to the Weight Tube (12) with an M8 x 45mm Bolt (60) and an M8 Nylon Locknut (69). Do not overtighten the Nylon Locknut; the Weight Tube must pivot easily in the Small "U"-bracket. 15. Identify the Press Cable (49). Slide the Cable 15 onto the hook on the Left Arm (7). 69 12 50 60 11 71 69 50 11 69 Hook 49 16. Apply grease to an M10 x 78mm Bolt (54). 16 Attach a Pulley Arm (38) to the Upright (3) with the Bolt and an M10 Nylon Locknut (68). Do not overtighten the Nylon Locknut; the Pulley Arm must pivot easily. Route the Press Cable (49) over a 90mm Pulley (34). Attach the Pulley, a Cable Trap (36), an M10 Washer (70), and two Finger Guards (35) to the indicated side of the Pulley Arm (38) with an M10 x 52mm Bolt (52) and an M10 Nylon Locknut (68). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 17. Route the Press Cable (49) under a 90mm 17 Pulley (34). Attach the Pulley and two Finger Guards (35) to the Double "U"-bracket (42) with an M10 x 46mm Bolt (53) and an M10 Nylon Locknut (68). 7 54 35 36 68 38 52 34 35 70 3 49 49 34 35 68 35 53 42 11