Weider 900 Uk Manual - Page 9

ARM ASSEMBLY 7 7. Apply grease to an M10 x 125mm Bolt (64). Orient the Press Frame (5) with the bracket on the side shown. Attach the Press Frame to the Top Frame (4) with the Bolt, two M10 Washers (70), and an M10 Nylon Locknut (68). Do not overtighten the Nylon Locknut; the Press Frame must pivot easily. 64 Grease 70 5 4 70 68 Bracket 8. Attach an Arm Pad (20) to the Left Butterly Arm (7) with two M6 x 58mm Screws (65) and two 8 M6 Washers (73). Apply grease to the post on top of the Left Arm (7). Orient a 25mm x 68mm Bushing (28) with 6 the lip in the position shown, and slide the Bushing onto the post. Repeat this step with the Right Butterfly Arm (6). 28 Lip Grease 7 20 73 65 73 9. Insert the post on the Left Butterfly Arm (7) into the left hole in the Press Frame (5). Make sure that the Left Arm is behind the indicated bracket on the Press Frame. Slide a 25mm Washer (29) onto the post on the Left Arm (7). Attach an M6 x 43mm Bolt (61) to the post with an M6 Nylon Locknut (72). Make sure that the Nylon Locknut and the head of the Bolt are overlapping the edge of the Washer, as shown in the inset drawing. Press a 25mm Round Outer Cap (27) onto the post on the Left Arm (7). Repeat this step with the Right Arm (6). 9 6 Post 61 5 Bracket 61 72 27 29 72 7 29 9