Weider 900 Uk Manual - Page 13
Identify the Low Cable 48.
View all Weider 900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
21. Route the Short Cable (47) over a 90mm Pulley 21 (34). Attach the Pulley and two Finger Guards (35) to the Double "U"-bracket (42) with an M10 x 46mm Bolt (53) and an M10 Nylon Locknut (68). 53 35 35 42 68 47 34 22. Attach the end of the Short Cable (47) to the "U"-bracket (43) with an M8 Washer (71) and an M8 Nylon Locknut (69). Note: Do not completely tighten the Nylon Locknut; it should be threaded onto the Cable so that two threads show past the Nylon Locknut, as shown in the inset drawing. 23. Identify the Low Cable (48). Attach the Cable inside the Base (1) with an M10 x 65mm Bolt (55), two M10 Washers (70), two Large Spacers (51), and an M10 Nylon Locknut (68). 22 47 43 69 23 47 43 71 69 55 70 51 1 48 51 70 68 24. Route the Low Cable (48) over a 90mm Pulley 24 (34). Attach the Pulley, a Cable Trap (36), and two Finger Guards (35) to the second hole from the bottom of each Pulley Plate (44) with an M10 x 52mm Bolt (52) and an M10 Nylon Locknut (68). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 52 35 36 48 44 35 68 34 13