Weider Club 8980 W English Manual - Page 13

18. Route the Press Arm Cable (30) through the Top 18 Cover (15). Wrap the Press Arm Cable (30) over a 3 1/2" Pulley (24). Attach the Pulley and a Cable Trap (28) to the Top Frame (4) with an M10 x 45mm Bolt (65) and an M10 Locknut (73). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 65 28 24 15 30 4 73 19. Attach the Press Arm (8) with the wire to the 19 Upright (3) with four M10 x 25mm Screws (58). Remove the M4 x 5mm Screw (69) and the Swivel Arm (16). Using the wire that is inserted into the Press Arm (8), route the Press Arm Cable (30) through the Press Arm as shown. Then, route the Cable through the Swivel Arm (16). Reattach the Swivel Arm (16) to the Press Arm (8) with the M4 x 5mm Screw (69). 16 30 69 58 8 58 3 20. Attach a 2 3/4" Pulley (23) to the right Press Arm (8) with an M10 x 53mm Button Bolt (61), two M10 Washers (71), two 5mm Spacers (25), two Guards (27), and an M10 Locknut (73). See the inset drawing. Orient the Guards and Pulley as shown. Make sure that the Press Arm Cable (30) is in the groove of the Pulley. 20 25 71 73 30 27 8 23 27 25 61 71 27 27 23 13