Weider E2000 English Manual - Page 6
Frame Assembly
View all Weider E2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Frame Assembly 1 1. Before beginning assembly, make sure you have read and understood the information on page 5. Open the parts bag labeled ÒFRAME ASSEMBLY.Ó Press a 2Ó Square Outer Cap (51) onto each end of the Stabilizer (5). Insert two 5/16Ó x 2 3/4Ó Carriage Bolts (14) up through the Stabilizer (5) and place it flat on the floor. 5 51 14 51 2. Press a 2Ó Square Inner Cap (21) into the end of the Base (8). Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (52) up through the Base (8). Place the Base (8) on the floor with the holes in the mounting bracket over the Carriage Bolts (14) in the Stabilizer (5). 2 14 5 Bracket 52 8 21 3. Press a 1Ó x 2Ó Inner Cap (11) into the top of the Rear 3 Upright (18). 11 Slide the Rear Upright (18) onto the 5/16Ó x 2 3/4Ó Carriage Bolts (14) in the Stabilizer (5). Hand tighten a 5/16Ó Nylon Locknut (53) onto each Carriage Bolt. Make sure the Rear Upright (18) is oriented as shown. The wide side of the bracket on the lower end must be on the side shown. Slide the Front Upright (42) onto the 5/16Ó x 2 1/2Ó 18 42 Carriage Bolts (52) in the Base (8). Hand tighten a 5/16Ó Nylon Locknut (53) onto each Carriage Bolt. Do not tighten the Nylon Locknuts yet. Wide 53 53 Side of the Bracket 53 5 53 14 8 52 6